ABB distributed control system IMSET01 programmable logic controller
Brand ABB Color Standard Application Industrial height 275mm rated current 510mA
Protection Level IP45 Suitable for motor power 356KW Applicable Site Power Industry BOM Number GJR2391500R1220 Power industry HIEE401782R0001 Part Number IMSET01
Applicable pipe 2 Whether imported is weighing 4.38 kg can be sold nationwide
ABB distributed control system IMSET01 programmable logic controller
The IMDSI1Digital input module is an interface for bringing 16 vertical process field signals into the INFI 90 open strategic process management system. These digital inputs are used by the control module to monitor and control the process. This note explains the digital input module specifications and operations for the IMDSI12, IMDSI13, IMDSI14, and IMDSI15 modules. It details the procedures required to complete the setup, installation, maintenance, troubleshooting and replacement of the module. The functionality of IMDSI12 is equivalent to that of the existing IMDSI02 module, except that IMDSI12 only provides a filter buffeting time of 17 milliseconds. As long as the jumper is set correctly, any IMDSI1 module can directly replace the imdsi02 module. For example, the IMDSI02 module can replace the IMDSI02 module with all jumpers set to 24 VDC and with a 17 ms de-jitter filter. System engineers or technicians using IMDSI1 digital input modules should read and understand this instruction before operating the module.
The input signal path and low isolation capacitance allow protection against fast transient burst disturbances. The threshold detection block circuit tests the input voltage to determine if it is at the appropriate voltage level to indicate the ONor OFF state. The output of this comparator is sent to a read buffer in the control logic block. If an input is activated, it will also cause the corresponding input status LED on the front panel to light up. The control logic block consists of a buffer holding the input and status byte values. The I/O expansion bus interface allows the control module to read these bytes. Input circuit description When the input signal is at the appropriate voltage level, the azener diode conducts (turns on) causing current to flow through the optocoupler. Configurable jumpers (on IMDSI12) or fixed resistors (on IMDSI13, IMDSI14, or IMDSI15) Select open thresholds and input voltages. The optocoupler output causes the comparator output to be low. This will light the corresponding status LED on the front panel of the module to indicate the power input; The I/O expansion bus interface transfers logic 1 to the control module on the I/Oexpander bus. When there is no input signal, no current passes through the optical coupler. The front panel LED is not on, and the DSI transmits logic 0 on the bus.
ABB distributed control system IMSET01 programmable logic controller
ABB 72395-4-0399123
ABB 751010R0815
ABB 81EU01E-E
ABB 83SR04C-E
ABB 83SR06B-E
ABB AB91-1 HESG437479R1 HESG437899
ABB AC800M 3BSE053240R1 PM891
ABB AFC094AE02
ABB AI620
ABB AI625
ABB AIM0016
ABB AM801F
ABB AM811F
ABB AO610
ABB ASE2UDC920AE01
ABB AV94A HESG440940R11 HESG216791/A
ABB BCU-12
ABB BIO0003
ABB BPL0001
ABB BRC3000A
ABB CB801
ABB CI534V02 3BSE010700R1
ABB CI535V30 3BSE022162R1
ABB CI541V1 3BSE014666R1
ABB CI547
